🛠️ 68110 Smog Pump Eliminator Bracket with Idler Pulley: Upgrade for 1979–1993 Ford Mustang 5.0L 302/351W

For owners of 1979–1993 Fox Body Ford Mustangs, the factory smog pump is one of the most troublesome stock components. It creates unnecessary engine drag, weakens throttle response, and often causes belt noise and premature wear.

Installing the 68110 Smog Pump Eliminator Bracket with Idler Pulley allows you to completely remove the restrictive factory smog pump. It maintains correct belt routing and tension while delivering a cleaner, more efficient engine setup for your 5.0L 302 / 351W Mustang.

💡 What Is a Smog Pump Eliminator Bracket?

The factory smog pump exists only for old emissions standards. It provides no performance benefit and gradually becomes a liability over time.

This aftermarket eliminator bracket replaces the smog pump position with a heavy-duty idler pulley. It stabilizes belt movement, eliminates parasitic loss, and keeps all engine accessories running normally.

📋 Vehicle Fitment Specs

✅ Key Fitment Advantage: 100% bolt-on design. No drilling, no cutting, and no custom belt adjustments needed.

🚀 Key Benefits

❓ Why Delete the Smog Pump?

The factory smog pump is purely an emissions leftover. It adds weight, clutter, and maintenance issues without any performance benefit.

Installing this 68110 eliminator bracket cleans up your engine bay, reduces unnecessary drag, and improves overall engine efficiency.

📦 Package Contents & Notes

📥 Inside the Box:

• 1 × 68110 Smog Pump Eliminator Bracket

• 1 × Pre-installed Idler Pulley

• 1 × Complete Mounting Hardware Kit
  

⚠️Important Note: This smog pump delete part is intended for off-road, racing, and classic restoration use only. Please check your local emissions laws before street driving.

💬 Frequently Asked Questions (FAQ)

Q1: Will deleting the smog pump hurt engine performance?

• A: No. The smog pump only affects emissions. Removing it reduces engine load and will not harm normal operation.

Q2: Do I need a new serpentine belt after installation?

• A: No. This bracket matches the original belt length and routing perfectly.

Q3: Is this hard to install?

• A: Completely bolt-on. Direct factory mounting points make installation quick, straightforward, and hassle-free.