Engine Lube Oil Filter 5698036 569-8036 for CAT Equipment | Maintenance Guide

Keep your CAT engine reliable, reduce downtime, and avoid costly repairs with the correct oil filter and proper installation.

Common Pain Points of Using Poor Oil Filters

• Insufficient filtration causes metal debris, accelerated engine wear, and expensive overhauls

• Ill-fitting or low-quality filters lead to oil leaks, pressure loss, and unexpected work stoppages

• Mismatched models waste time on returns, rework, and delayed maintenance

• Short service life means more frequent changes and higher long-term costs

Step-by-Step Installation Guide

1. Prepare the machine

   
   

   Park on level ground, turn off the engine, and let it cool completely. Prepare a drain pan, filter wrench, and clean cloths.
   
   
2. Remove the old filter

   
   

   Place the pan under the filter. Use a filter wrench to loosen and remove the old oil filter.
   
   
3. Clean the mounting base

   
   

   Wipe the filter seat completely clean with a cloth to remove dirt, old oil, and debris.
   
   
4. Prep the new filter

   
   

   Apply a thin layer of clean engine oil to the rubber O‑ring on the new 569-8036 filter.
   
   
5. Install the new filter

   
   

   Screw on the new filter by hand until the O‑ring seats, then tighten an additional ¾ turn with a wrench.
   
   
6. Finish and check

   
   

   Refill with the recommended engine oil, start the engine, idle briefly, and check for leaks. Confirm normal oil pressure.

Buy Genuine 5698036 569-8036 Oil Filter Here